The Unitree Dex5-S is Unitree's 22-degree-of-freedom dexterous robotic hand, built at 1:1 human-hand scale with every joint driven by its own motor. The thumb has five degrees of freedom, the index, middle and ring fingers four each, and the little finger five, including a roll axis; all 22 joints are backdrivable, carry dual encoders and run on precision micro gearboxes.
That full actuation separates it from Unitree's Dex5-1, which has 20 degrees of freedom with 16 active, weighs 1,100 g and connects over USB. The Dex5-S puts more motion into a smaller hand: 620 g in an aluminium-alloy housing measuring 102 × 187 × 26 mm, holding 1 kg continuously and 2 kg at peak. It suits research teams and humanoid builders working on teleoperation, in-hand manipulation and learning from human demonstration, where a hand the size of the operator's keeps motion mapping direct.
Every joint has an impact-protection structure that shields its gears when the joint takes an extreme external blow. The hand runs on 15–65 V through an XT30 connector with a 200 W peak and connects by Gigabit Ethernet (two T1s ports, 1000BASE-T1), USB or high-speed RS-485 at 6 Mbps; Ethernet and USB close the control loop at 1,000 Hz and RS-485 at 50 Hz. In the Ethernet configuration a palm camera plugs straight into the hand. Each joint takes mode, position, velocity, torque, stiffness and damping commands and reports mode, position, velocity, torque, temperature, voltage and current.
This is the Dex5-S without tactile sensing; the Dex5-S Pro adds it to the same hand. Hand side and mounting to your arm or humanoid are confirmed with the quotation. Compare it with the rest of our dexterous robotic hands.
Key Capabilities
-
22 joints, all motor-driven: Five in the thumb, four each in the index, middle and ring fingers, and five in the little finger, which gains a roll axis.
-
Human-hand scale at 620 g: An aluminium-alloy hand measuring 102 × 187 × 26 mm that holds 1 kg continuously and 2 kg at peak.
-
Impact protection on every joint: A protection structure shields the precision micro gearboxes when a joint takes an extreme external blow.
-
Backdrivable, with dual encoders: Every joint can be back-driven and reports its position through two encoders.
-
Gigabit Ethernet, USB or RS-485: Two T1s Ethernet ports and USB run the control loop at 1,000 Hz and high-speed RS-485 at 50 Hz, and in the Ethernet configuration a palm camera plugs straight into the hand.
-
15–65 V through XT30: The hand takes a wide supply range through an XT30 connector and draws up to 200 W at peak.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.