The CR16A is the heavy-but-close arm of Dobot's CRA series. It lifts 16 kg within a compact 1,000 mm reach, from a 40 kg arm, for dense loads that do not travel far: steel blanks into a lathe, heavy castings onto a fixture, full cases off a conveyor beside the robot.
Keeping the reach short keeps the cell small. Where a 20 kg arm needs room for a 1,700 mm envelope, the CR16A works within 1,000 mm, so guarding and floor space stay modest. Repeatability is ±0.03 mm and maximum TCP speed 2 m/s.
It speaks the CRA range's protocols: TCP/IP, Modbus TCP, EtherNet/IP and PROFINET on two WAN ports, Modbus RTU on RS-485 and Wi-Fi. The controller runs on single-phase 100 to 240 V AC at 47 to 63 Hz and the arm draws 350 W.
The arm is rated IP54, works from 0 to 50 °C and is built from aluminium alloy and ABS. Count the gripper in the 16 kg, and plan a base rigid enough for heavy parts moved at speed.
Key Capabilities
-
16 kg within 1,000 mm: A high payload in a compact envelope, for dense loads that stay close to the base.
-
Small cell footprint: The short reach keeps guarding and floor space modest.
-
±0.03 mm repeatability: Heavy parts are placed consistently into fixtures and machines.
-
40 kg arm, 350 W: The arm weighs 40 kg and draws 350 W from single-phase mains.
-
PLC-ready: TCP/IP, Modbus TCP, EtherNet/IP and PROFINET on two WAN ports, Modbus RTU over RS-485 and Wi-Fi.
-
IP54 arm: Rated for dust and splash exposure, from 0 to 50 °C.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation, and on-site installation is not included in the product price.