The BrainCo Revo 2 Pro (XEL) is the left-hand Pro version of BrainCo's Revo 2 bionic dexterous robotic hand, built for robots that run their joints on EtherCAT. It keeps the Revo 2 mechanism, 383 g with 11 degrees of freedom from six coreless motors, and adds an EtherCAT port and a 12–64 V input to the RS-485 and CAN FD of the Basic.
EtherCAT matters when the hand has to move in step with the arm. With CoE and PDO the Pro exchanges commands and state at up to 1 kHz, where RS-485 and CAN FD top out at 500 Hz, so a humanoid or arm controller can treat the fingers as more axes in the same cycle. The wide supply runs straight from a 24 V or 48 V rail, and at 24 V the hand idles at 115 mA and peaks at 4.65 A. Position, velocity, current, cascaded and compliance control and five command modes (position with a time or speed limit, speed, current and PWM) come with BrainCo's Python and C/C++ SDKs on Linux, Windows and ROS.
The hand measures 160 mm from palm base to middle fingertip and 78.5 mm across the palm, grips with at least 50 N, pinches with 15 N, carries at least 20 kg and repeats to 0.1°. The Revo 2 Basic left hand (XRL) is the same hand on RS-485 or CAN FD only, at 12–28 V, and the Revo 2 Touch left hand (XTL) is the Pro with capacitive tactile sensors in every fingertip and tactile adaptive control.
This is the left hand, device ID 126 by default; the Revo 2 Pro right hand (XER) uses 127, and both arrive with RS-485/CAN FD, EtherCAT and power cables. The wrist mounts with four M3 screws into 3.5 mm threaded holes, so screws should enter no more than 3 mm; fitment to your arm is confirmed with the quotation. See our other dexterous robotic hands for different makers and designs.
Key Capabilities
-
EtherCAT at up to 1 kHz: EtherCAT with CoE and PDO runs at up to 1 kHz, twice the 500 Hz of the RS-485 and CAN FD ports the Pro also carries.
-
12–64 V supply: The wide input runs from a 24 V or 48 V rail; at 24 V the hand draws 115 mA at rest and 4.65 A at peak.
-
A connector for each bus: RS-485, CAN FD and EtherCAT each have their own connector under the wrist, beside an XT30 power input.
-
383 g, 20 kg payload: The left hand weighs 383 g, grips with at least 50 N, pinches with at least 15 N and carries at least 20 kg.
-
11 degrees of freedom: Six coreless motors drive the thumb's flexion and abduction and each finger's flexion, five joints follow passively, and control repeats to 0.1°.
-
Python, C/C++ and ROS: BrainCo's SDKs run on Linux, Windows and ROS, with URDF and MuJoCo models and over-the-air firmware updates.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.