The BrainCo Revo 2 Pro Right (XER) is the right-hand bionic dexterous robotic hand of BrainCo's Revo 2 Pro version, the step up from the Basic for robots built around EtherCAT. Its five fingers carry 11 degrees of freedom, six of them driven by coreless motors, in a hand of 383 g that is 160 mm long and 78.5 mm across the palm.
Many humanoids and collaborative arms run their joints on EtherCAT, and the XER joins that network directly: CoE and PDO at up to 1 kHz, with RS-485 (Modbus-RTU) and CAN FD at up to 500 Hz on separate connectors for simpler setups. It runs from 12 to 64 V through an XT30 connector and draws 115 mA at rest at 24 V. The control stack is the same across the Revo 2: position, velocity and current control with cascaded and compliance control, five command modes and a turbo mode that keeps re-gripping a soft or shifting object after a stall.
Mechanically the Pro equals the other Revo 2 versions: at least 50 N grip, 15 N pinch, a payload of at least 20 kg, 100 mm opening between thumb and index finger, 0.1° repeat precision and 0.65 s or less per flex or extension. The Revo 2 Basic right hand (XRR) drops EtherCAT and runs on 12–28 V; the Revo 2 Touch right hand (XTR) keeps the Pro's interfaces and adds a capacitive tactile sensor in every fingertip.
Out of the box the XER uses device ID 127 and the Revo 2 Pro left hand (XEL) 126, so a two-handed robot addresses both on one bus. The package holds the hand with RS-485/CAN FD, EtherCAT and power cables; BrainCo's Python and C/C++ SDKs run on Linux, Windows and ROS, and the firmware updates over the air. For other makes and models, see our dexterous robotic hands.
Key Capabilities
-
EtherCAT for real-time arms: CoE and PDO over EtherCAT give a control rate of up to 1 kHz, so the fingers can run in the same cycle as an EtherCAT arm.
-
Three interfaces, one hand: EtherCAT, CAN FD and RS-485 (Modbus-RTU) each have a connector under the wrist; the two serial buses run at up to 500 Hz.
-
Runs from 12 to 64 V: At 24 V it draws 115 mA standing still, 390 mA on average flexing with no load and 4.65 A at most.
-
Six motors, 11 degrees of freedom: Driven thumb flexion (0–59°) and abduction (0–90°), driven flexion in each finger (0–81°) and five passive joints repeat to 0.1°.
-
At least 50 N grip: The 383 g hand grips with at least 50 N, pinches with 15 N and holds at least 20 kg.
-
Simulation-ready: URDF models for ROS 1 and ROS 2 and a MuJoCo model sit alongside BrainCo's Python and C/C++ SDKs.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.