The Unitree Dex2/5 is Unitree's tendon-driven five-finger dexterous robotic hand for the G1 and R1 humanoids. Its five fingers carry ten joints, but only two are actuated: one moves the thumb and one moves the index, middle, ring and little fingers together, through a gear-tendon rope drive routed inside the hand.
That design gives up individual finger control in exchange for a simple, light and tough hand. It weighs 365 g, measures 151 × 70 × 63 mm flat, closes into a fist in 0.5 s and grips objects down to 8 mm across. Unitree has put the complete hand through more than 100,000 fatigue cycles and over 100 drop tests, which suits classrooms, demonstrations and robots that bump into things.
Fingertip force is 15 N at the thumb and 15 N shared across the four fingers, and with the palm down or turned left the hand holds up to 1.5 kg on a 5 cm round hard object. It runs from 24–60 V, communicates over RS-485 at 1,000 Hz, reports joint mode, position, velocity, torque, temperature, voltage and current, and accepts position, velocity, torque, stiffness and damping settings. Hand side, quantity and mounting are confirmed with the quotation.
For individual finger control on a G1, the three-finger Unitree Dex3-1 for the G1 drives 7 force-controlled degrees of freedom, and the Unitree Dex5-S drives all 22 of its joints. See the rest of our dexterous robotic hands to compare.
Key Capabilities
-
Two actuators, ten joints: One actuator moves the thumb and one moves the four fingers together, which keeps control simple.
-
Gear-tendon rope drive: Tendons carry the motion to the finger joints, with the drive routed inside the hand.
-
365 g five-finger hand: It measures 151 × 70 × 63 mm flat, light enough for a compact humanoid's wrist.
-
Tested for knocks: Unitree has put the complete hand through more than 100,000 fatigue cycles and over 100 drop tests.
-
Holds up to 1.5 kg: Grasping a 5 cm round hard object, palm down or palm left, it holds up to 1.5 kg and closes into a fist in 0.5 s.
-
RS-485 at 1,000 Hz: It reports position, velocity, torque, temperature, voltage and current, and accepts stiffness and damping settings.
-
Made for the G1 and R1: Unitree builds the Dex2/5 for its G1 and R1 humanoids.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.