DFRobot - Romeo V2-All in one Controller

Name: DFRobot - Romeo V2-All in one Controller
Brand: DFRobot
SKU: DF-DFR0225
Price: 39.92 GBP
Availability: InStock

DFRobot · Romeo V2-All in one Controller

£39,92

Skick

New

RoboSavvy

Gå till butiken

Beskrivning

DFRobot - Romeo V2-All in one Controller Introduction RoMeo V2[R3]is an All-in-One Arduino compatible microcontroller especially designed for robotics applications from DFRobot. The Romeo benefits from the Arduino open source platform, it is supported by thousands of open source codes, and can easily be expanded with Arduino Shields. The integrated 2 way DC motor driver and Xbee socket allows you to start your project immediatly without the need for an additional motor driver or wirless shield. Another improvement of Romeo V2 is that it supports stepper motor control. The RoMeo V2[R3] behaves like Arduino Leonardo based on the ATmega32u4 chip,You can program it directly from the Arduino IDE 1.0.1 or later version.Because of the ATmega32U4 as its sole microcontroller, allows the RoMeo V2 to be simpler to use.Also,The 32U4 is handling the USB directly, code libraries are available which allow the board to emulate a computer keyboard, mouse, and more using the USB-HID protocol! The best advantage is that ATmega32u4 has two serial ports which allows you uploading sketches without removing wireless modules. Debuging is no longer a pain work. Romeo V2 also improves the power supply, it has now a switch to select power source either from USB or external power. Warning:The analog sensor port pin mapping on RoMeo v2 is different from the old version. Please select Arduino Leonardo board when using Arduino IDE. Specification DC Supply:USB Powered or External 6V~23V DC DC Output:5V(2A) / 3.3V DC Motor driver Continuous Output Current:2A Microcontroller:ATmega32u4 Bootloader: Arduino Leonardo Compatible with the Arduino R3 pin mapping Analog Inputs: A0-A5, A6 - A11 (on digital pins 4, 6, 8, 9, 10, and 12) PWM: 3, 5, 6, 9, 10, 11, and 13. Provide 8-bit PWM output 5 key inputs for testing Auto sensing/switching external power input Serial Interface TTL Level USB Support Male and Female Pin Header Built-in Xbee socket Integrated sockets for APC220 RF Module and DF-Bluetooth Module Three I2C/TWI Interface Pin Sets(two 90°pin headers) Two way Motor Driver with 2A maximum current One Stepper Motor Drive with 2A maximum current Size:89x84x14mm Improvement compared with Romeo v1.1 Wide operating input voltage Directly support Xbee and XBee form factor wifi,bluetooth and RF modules ON/OFF switch to control the system power from extermal motor power 3 Digital I/O extension(D14-D16) S1-S5 switch replace jump cap Micro USB instead of A-B USB connector Analog sensor extension port: Orange for Signal,Red for Vcc,Black for GND Shipping List Romeo V2-All in one Controller (1 unit) Documents Wiki Doc Romeo V2 schematic Trick for changing the sensor cable pin mapping Drive Stepper motor with Romeo v2 Romeo stepper motor library Videos Hongkong biped robot using Romeo Arduino RC Hack based on Romeo v1 Android controlled time-lapse photography - Submitted by MakoShark2 Projects Raspberry Internet Rover(Based on Pirate 4WD platform and Romeo V2) Introduction  

Prishistorik