The BrainCo Revo 2 Basic (XRL) is the left-hand Basic version of BrainCo's Revo 2 bionic dexterous robotic hand: the same 383 g, 11-degree-of-freedom mechanism as the Pro and Touch, without EtherCAT or fingertip sensors. Six coreless motors drive the thumb's flexion and abduction and the flexion of each finger, five passive joints follow them, and the hand measures 160 mm from palm base to middle fingertip and 78.5 mm across the palm.
It suits labs, teaching programmes and humanoid builders who need a capable human-sized hand on a standard serial bus. A DIP switch under the wrist cover selects Modbus-RTU over RS-485 or CAN FD, both at up to 500 Hz, and the hand runs on 12–28 V, idling at 65 mA at 24 V. BrainCo's Python and C/C++ SDKs cover Linux, Windows and ROS, with URDF and MuJoCo models for simulation and over-the-air firmware updates.
Strength matches the rest of the range: at least 50 N five-finger grip, 15 N pinch, a 20 kg payload, 0.1° repeat precision and a full flex or extension in 0.65 s or less, at no more than 50 dB. The Revo 2 Pro left hand (XEL) adds EtherCAT at up to 1 kHz and a 12–64 V input, and the Revo 2 Touch left hand (XTL) adds capacitive sensors in all five fingertips on top of that.
This hand is set to device ID 126; the Revo 2 Basic right hand (XRR) uses 127, so a pair can share one bus. The box holds the hand and one RS-485/CAN FD cable. For a Unitree H2 there is a Revo 2 Basic hand configured for the H2, and our full range of dexterous robotic hands covers other makers.
Key Capabilities
-
Lowest power draw in the Revo 2 range: At 24 V the Basic idles at 65 mA and averages 350 mA flexing all five fingers with no load, on a 12–28 V supply.
-
RS-485 or CAN FD by switch: A DIP switch under the wrist cover selects Modbus-RTU over RS-485 or CAN FD, both at up to 500 Hz, on one five-pin connector.
-
383 g with a 20 kg payload: The hand weighs 383 g, grips with at least 50 N, pinches with at least 15 N and carries at least 20 kg.
-
11 degrees of freedom: Six coreless motors drive two thumb joints and one joint per finger, five further joints follow passively, and positions repeat to 0.1°.
-
Cascaded and compliance control: Besides position, velocity and current control, the Basic runs cascaded and compliance control, and a turbo mode keeps re-gripping soft or shifting objects.
-
Python, C/C++ and ROS: BrainCo's SDKs run on Linux, Windows and ROS, URDF and MuJoCo models are provided, and the firmware updates over the air.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.