Prezz medju ta’ kuljum
Ammonti f{currency}
Sabertooth 2x12A Regenerative Motor Driver 6V-24V
Dimension Engineering | A-000000-02985
€88.68 VAT incl.
€73.90 VAT excl.
Let your Sabertooth control and supply two DC motors, a microcontroller and a couple of servos, and your robot will reach new highs in manoeuvrability and autonomy!
Payment methods
(see T&C)
Debit card
PayPal
Payment by invoice
Wire transfer
A Sabertooth 2x12A to control and supply your motors
The Sabertooth driver from Dimension Engineering allows you to control 2 brushed DC motors at currents of up to 12A each. Peak currents of 25A are achievable for a few seconds. There are different control modes accessible via analogue, R/C or serial inputs. The driver also has independent speed and direction operating modes.
Plus, the built-in 1A-5V DC-DC converter can provide power to a microcontroller or R/C receiver and a couple of servos.
Overcurrent and thermal protection means you’ll never have to worry about damaging the driver by hooking up too big a motor.
The first regenerative motor driver in its class
“Regenerative” means that your batteries get recharged whenever the driver commands your robot to slow down or reverse. Difficult to run out of power as the driver gets fully charged while you’re steering your robot! And the Sabertooth driver also allows you to make very fast stops and turns, giving your robot a nimble edge.
Technical specifications of the Sabertooth rb-dim-42
- Sabertooth 2x12 model
- Power:
- 12A continuous
- 25A peak per channel
- Up to 24V input current
- Synchronous regenerative drive
- Ultrasonic switching frequency
- Thermal and overcurrent protection
- Lithium protection mode
- Inputs: analogue, R/C and serial (plain/packetised)
- Dimensions: 59 × 75 × 17 mm
Resources for the Sabertooth
Review the extensive collection of documents below for using your Sabertooth driver:
Storja tal-prezzijiet
Storja tal-prezz medju
Punt tad-dejta wieħed għal kull jum, ikkalkulat bħala medja skont id-data tal-osservazzjoni.
$99.30
Il-medji jiġu kkalkulati għal kull jum UTC mill-prezzijiet kollha tal-offerti rreġistrati.
Elenki relatati
Unitree Go2 Battery charger (standard charge version)
Unitree
$90
Unitree B2 Foot Pad
Unitree
$90
Single mounting bracket for the LMS100 and LMS111
Unitree
87.26 €
Battery charger for the NAO humanoid robot
Unitree
96 €
LIPO 11.1V 1,800mAh LB-012 Battery
Unitree
86.95 €
Official Raspberry Pi 3 B Starter Kit
Unitree
94.80 €
GMSL2 Fakra 1-to-4 M-F Cable for Zed X Camera - Stereolabs
Unitree
90 €
Raspberry Pi Compute Module 4 – 8 GB RAM
Unitree
90 €
Unitree B2 Roboterhund Pußpad (1. Stück)
Unitree
85 €
M12 power cable with 8 pins for Sick LMS111 laser scanner
Unitree
78.25 €
SyRen 25 Motor Driver
Unitree
75.60 €
Pixy2 v2.1 Camera Sensor
Unitree
75.60 €