The CR7A puts more payload into a tighter envelope. It carries 7 kg over an 800 mm reach and weighs 24.5 kg, half a kilogram less than the 5 kg CR5A, which makes it the arm for compact cells where the gripper and part have outgrown 5 kg but the work still sits close to the base.
Typical jobs are screwdriving with a heavier driver, loading dense parts into a fixture, packing and small-machine tending. Repeatability is ±0.02 mm and the tool centre point moves at up to 2 m/s.
Connectivity matches the rest of the CRA range: two WAN ports for TCP/IP, Modbus TCP, EtherNet/IP and PROFINET, an RS-485 port for Modbus RTU, and built-in Wi-Fi. The controller runs on 100 to 240 V AC at 47 to 63 Hz and the arm draws 150 W.
It is rated IP54, works from 0 to 50 °C and is built from aluminium alloy and ABS. If the work needs more than 800 mm of reach at 5 kg or less, the CR5A covers 900 mm.
Key Capabilities
-
7 kg in an 800 mm envelope: More payload than the CR5A for compact cells where the work sits close to the base.
-
24.5 kg arm: Light enough for small stands and carts despite the higher payload.
-
±0.02 mm repeatability: Placement stays precise with heavier tools at the flange.
-
2 m/s TCP speed: The tool centre point moves at up to 2 m/s.
-
Line-ready protocols: TCP/IP, Modbus TCP, EtherNet/IP and PROFINET on two WAN ports, Modbus RTU over RS-485 and Wi-Fi.
-
150 W from single-phase mains: The controller takes 100 to 240 V AC at 47 to 63 Hz.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation, and on-site installation is not included in the product price.