The Dex1-1 is the two-finger parallel gripper Unitree offers as the simplest end effector for its humanoid arms. It is a jaw, not a hand: one actuator, an 80 mm jaw and 90 mm of travel, aimed at pick-and-place work where a five-finger hand would be over-specified.
The mechanism is capable for its size. Gripping force is set in software anywhere between 5 N and 120 N, speed between 50 mm/s and 375 mm/s, and fingertip position resolves to 0.1 mm. A form-fitting horizontal grasp is rated to 20 kg, a friction grasp to 5 kg vertically on a square steel block, and the full stroke closes in as little as 0.24 s.
The Standard edition is the one distinction that matters when choosing between the three Dex1-1 configurations: it carries no camera. The Advanced edition adds a 1080p RGB camera on the same mechanism, and the Ultimate edition sits above it. If vision on your robot comes from the head or from an external rig, the Standard edition is the configuration to order.
Control is over high-speed RS-485 at a 6 Mbps baud rate and a 1000 Hz control frequency, with angle, angular velocity, torque and temperature fed back and angle, velocity, torque, stiffness and damping accepted as commands. Unitree lists the gripper for the G1, H1, H2 and R1 humanoids and for standalone use; fitment against your own arm configuration is confirmed before order.
Key Capabilities
-
Two-finger parallel jaw, 90 mm stroke: An 80 mm jaw travels the full 90 mm stroke in as little as 0.24 s.
-
Gripping force set in software from 5 N to 120 N: Force and speed are both adjustable, so one gripper handles a thin-walled container and a steel block.
-
No camera in this edition: The Standard configuration omits the 1080p RGB camera the Advanced edition carries, for teams whose vision comes from elsewhere on the robot.
-
20 kg form-fitting load: Horizontal form-fitting grasps are rated to 20 kg and friction grasps to 5 kg vertically on a square steel block.
-
0.1 mm fingertip resolution at 1000 Hz: High-speed RS-485 at 6 Mbps carries angle, angular velocity, torque and temperature feedback at a 1000 Hz control frequency.
-
Fits the Unitree humanoid range: Unitree lists G1, H1, H2 and R1 compatibility as well as standalone operation, and we confirm fitment against your configuration before order.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.