The Robotera XHAND1 Lite, which Robotera calls its “Agile Elf Hand”, is a slim five-finger dexterous robotic hand of human-hand size, built for speed and for slim humanoid and service robots. It weighs 730 g and measures 209 × 84 × 32 mm, against 1,100 g and 47 mm thickness for the full XHAND1, and Robotera fits it to its own Q5 wheeled humanoid.
It has 11 degrees of freedom, 6 active and 5 passive. The thumb has two driven joints plus a passive one, and each of the four fingers one driven joint plus a passive one, coupled through linkages and micro force-controlled composite joints. The thumb still reaches the little finger in opposition, and the joints are backdrivable, which Robotera ties to fault-tolerant data collection and a higher inference success rate.
Speed is its strength: fast response up to 10 clicks per second and an open-close rate above 2 Hz, for gestures and interactive tasks. Each fingertip carries 12 N, the hand grasps objects from 12 mm across, Robotera rates the single-hand payload at 10 kg, and fingertips repeat to ±0.20 mm. It is rated for one million no-load grasp cycles.
Control runs over EtherCAT at 100 Mbps or RS-485 at 3 Mbps via USB, in position mode with low or high damping, or in current-loop force control. Hand side, tactile options and operating voltage are confirmed with the quotation.
For research that needs every joint driven, the full XHAND1, sold as a right hand and a left hand, has 12 active degrees of freedom, 270° tactile fingertips and up to 80 N of grip. Compare the rest of our dexterous robotic hands.
Key Capabilities
-
730 g and 32 mm thin: At 209 × 84 × 32 mm and 730 g, it suits slim humanoid and service-robot arms.
-
11 DoF, 6 of them driven: Two driven thumb joints and one in each finger, plus five passive joints coupled through linkages.
-
Up to 10 clicks per second: Fast response and an open-close rate above 2 Hz suit gestures and interactive tasks.
-
10 kg single-hand payload: Robotera rates the hand at 10 kg, with 12 N per fingertip and grasps from 12 mm diameter.
-
Backdrivable joints: The joints back-drive under load, and the thumb opposes every finger down to the little finger.
-
EtherCAT or RS-485: EtherCAT at 100 Mbps or RS-485 at 3 Mbps, with position and current-loop force control.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.