The BrainCo Revo 2 Basic Right (XRR) is the right-hand bionic dexterous robotic hand that starts BrainCo's Revo 2 range. It weighs 383 g, which BrainCo compares to a bottle of water, measures 160 mm from palm base to middle fingertip, and moves five fingers through 11 degrees of freedom with six coreless motors.
Choose the Basic when the controller already speaks RS-485 or CAN and the work is grasping rather than sensing: pick-and-place, teleoperation, demonstration robots and manipulation courses. A DIP switch under the wrist cover sets Modbus-RTU over RS-485 or CAN FD, each at up to 500 Hz; the supply is 12–28 V, and at 24 V the hand draws 65 mA at rest and 350 mA on average while flexing without load. Position, velocity, current, cascaded and compliance control are all built in, and a turbo mode re-grips soft or shifting objects every 500 ms after a stall.
The fingers close with at least 50 N, pinch with 15 N and hold at least 20 kg, open 100 mm between thumb and index finger, and complete a flex or extension in 0.65 s or less. Moving up the range keeps that hardware: the Revo 2 Pro right hand (XER) adds EtherCAT at up to 1 kHz and a 12–64 V input, and the Revo 2 Touch right hand (XTR) also senses with all five fingertips.
Out of the box the XRR answers to device ID 127, while the Revo 2 Basic left hand (XRL) answers to 126, so both hands of a humanoid run on one bus. Each comes with an RS-485/CAN FD cable, and BrainCo's Python and C/C++ SDKs, URDF and MuJoCo models and over-the-air firmware updates support it on Linux, Windows and ROS. Compare it with the rest of our dexterous robotic hands.
Key Capabilities
-
11 degrees of freedom on six motors: The thumb gets driven flexion and abduction, each finger a driven flexion joint coupled to a passive one, and every position repeats to 0.1°.
-
20 kg from a 383 g hand: A five-finger grip of at least 50 N and a 15 N pinch let the 383 g right hand carry at least 20 kg.
-
One connector, two protocols: The DIP switch under the wrist cover sets Modbus-RTU over RS-485 or CAN FD, and either one reaches 500 Hz.
-
Light on power: The Basic takes 12–28 V and draws 65 mA at rest and 4.6 A at peak at 24 V, the lowest figures in the Revo 2 range.
-
Built-in protection: Current, stall, over-temperature and collision protection guard the motors, and a light on the back of the hand shows power-up, low voltage, OTA and fault states.
-
Open SDK and simulation models: Python and C/C++ SDKs for Linux, Windows and ROS come with URDF and MuJoCo models of the hand.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation — on-site installation is not included in the product price.