The Dobot Smart Pendant is a hand-held teach pendant for manual operation, programming, parameter setup and monitoring of a Dobot robot at the cell. It works with the Magician E6, Nova-DSC and CRA series robots, among them the Dobot CR3A. Dobot part number 1200000242.
It connects to the robot controller by cable rather than wireless, with 4.5 m between the pendant and the controller. That is enough to stand back from the arm while jogging it or stepping through a program, and a wired link means the pendant does not drop out in the middle of a teaching session.
The pendant weighs 1.09 kg, is rated IP54 against dust and splashing water, and works from 0 to 50 °C, so it suits a shop floor as well as a lab or classroom.
Teams that program on a laptop or tablet day to day still find a pendant useful at the cell: for jogging the arm into position, adjusting points and parameters, and watching the robot's status without walking back to a desk.
Key Capabilities
-
Hand-held control at the cell: Operate, program, configure and monitor the robot from a pendant held next to the arm.
-
Wired, 4.5 m cable: A cable link of 4.5 m to the controller gives room to step back from the robot without dropouts.
-
IP54 rated: The pendant is protected against dust and splashing water for shop-floor use.
-
0 to 50 °C working range: It works across a wide temperature range, from cold workshops to warm production halls.
-
1.09 kg: The pendant is light enough to hold through a teaching session.
-
Several Dobot robot families: It works with the Magician E6, Nova-DSC and CRA series robots.
Buying through Robotix Market
This unit is sourced new through established distribution channels and ships worldwide with the manufacturer warranty. Technical support is coordinated with the manufacturer's own service network. Deployment scope, configuration, and commissioning responsibilities are agreed as part of the quotation. On-site installation is not included in the product price.